DIY

Diy Glowing Table With Burned Wood

This Diy glowing table is handmade. And the materials that are used are natural. The procedure for making this project is simple and the final result will be amazing.

Diy Glowing Table With Burned Wood (4)

Diy Glowing Table With Burned Wood (5)

Materials needed for this project:

  • Wooden beams
  • Epoxy resin
  • Propane torch
  • Cutting tools

First you need four or five wooden beams that need to be in the same dimensions. And you need to burn them. But not completely, only the surface. After that to place two beams under the burned beams. And to hammer the nails like on the picture.

Diy Glowing Table With Burned Wood (9)

Diy Glowing Table With Burned Wood (7)

Diy Glowing Table With Burned Wood (8)

Next step is to make mold with dimensions, for putting the wooden construction inside. Now is the time for fulfilling with epoxy resin. Place the wooden construction inside and wait for everything to dry, about 24 hours.

Diy Glowing Table With Burned Wood (10)

Diy Glowing Table With Burned Wood (1)

For smoothing the surface you will need propane torch. With the propane torch make lowest settings possible wave the flame over the table. And to be 6 inches away. All the bubble formation will poop.

Diy Glowing Table With Burned Wood (2)

Diy Glowing Table With Burned Wood (3)

You need to make some construction for holding the table. From iron or wooden material your choice.

Diy Glowing Table With Burned Wood (6)

Leave a Reply

Your email address will not be published. Required fields are marked *